Testing The Manual Scanner Registration - Lexmark X940e Service Manual

7510-XXX

Testing the manual scanner registration

Note: Machine must be in Standard User Mode.
To properly position the Network Setup Page which will be used as the ADF test original page on the flatbed
scanner and the ADF side 1 and ADF side 2, follow the graphic below:
Warning: Ensure that the Network Setup Page is properly positioned according to the diagrams, or registration
and margins cannot be properly adjusted.
1. Place the Network Setup Page on the flatbed scanner according to the graphic below.
2. Make a copy of the Network Setup Page, and mark it "Flatbed".
3. Place the Network Setup Page, image side up, in the ADF according to the diagram below. This will be the
ADF side 1 registration test.
4. Make a copy of the Network Setup Page, and mark it "ADF side 1".
5. Place the Network Setup Page, image side down, in the ADF according to the diagram below. This will be
the ADF side 2 registration test.
6. Select "2 sided to 2 sided" while in copy mode to ensure that the rear side of the test original page is
copied.
7. Make a copy of the Network Setup Page, and mark it "ADF side 2".
Note: You should now have three test copies of the Network Setup Page.
3-30
MFP Service Manual