Waste Toner Agitator Motor Assembly Removal; Pc Cartridge Unit Removal - Lexmark X940e Service Manual

7510-XXX

Waste toner agitator motor assembly removal

1. Remove the printer front door assembly. See
2. Remove the front left cover. See
3. Remove the waste toner cartridge cover. See
4. Remove the waste toner cartridge sensor assembly. See
page 4-39.
5. Remove the inner cover. See
6. Disconnect the connector from the waste toner agitator motor assembly (A).
7. Remove the two screws securing the waste toner agitator motor assembly (A) to the machine.
8. Remove the waste toner agitator motor assembly (A).

PC cartridge unit removal

Note: The following procedure applies to the C, M, Y, and K PC cartridge units.
Warning: When removing or installing the PC cartridge units, do not touch the drum surfaces, or damage will
occur.
Warning: When removing the PC cartridge units, ensure that the drum surfaces are not exposed to any sources of
light, or damage will occur.
1. Open the printer front door.
2. Press the button, and raise the transfer belt lift latch assembly (A) to its upper-most position.
3. Lower the transfer belt lift handle (B) to its lower-most position.
4. Gently pull the appropriate PC cartridge assembly (B) out of the machine.
Warning: When placing the PC cartridge units on a level surface, ensure that no part of the OPC drum or any
roller comes into contact with the resting surface.
4-44
MFP Service Manual
"Printer front door assembly removal" on page
"Front left cover removal" on page
"Waste toner cartridge cover removal" on page
"Inner cover removal" on page
A
4-9.
"Waste toner cartridge sensor assembly removal" on
4-43.
Connector
4-3.
4-39.