Lexmark X940e Service Manual page 650

7510-XXX
Step
2 Perform the Skew fine setup printhead adjustment.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Cycle result values
Locate the following new values for the following settings:
Y- Skew adjustment
M- Skew adjustment
C- Skew adjustment
K- Skew adjustment
Turn the appropriate printhead adjustment screws, located
behind the waste toner cartridge, the number of clicks
(rotation until a snap sound is heard and felt) based on the
above settings.
+values require turning the screw Clockwise
- values require turning the screw Counter Clockwise.
EG: Y-Skew adjustment 10. Turn the screw CW 10 clicks.
EG: Y-Skew adjustment -10. Turn the screw CCW 10 clicks.
Have the appropriate printhead adjustment screws been
adjusted?
4-258
MFP Service Manual
Check
Printhead adjusting screw
K
C
M
Y
Yes
Perform the In/Out Adjust the
setup. printhead
adjustment screws
See "In/out
then perform the
setup" on
In/Out setup.
page 4-262.
See "In/out
setup" on
page
No
4-262.