7510-XXX
10. Remove the tray 4 front cables (C) from the bottom plates (F).
Replacement note: Before re-installing:
—
It is recommended that all four cables be replaced.
—
Ensure tray 4 front cables (C) are not twisted or kinked.
—
Route the cables properly as shown in the figure.
—
Replace the cables by setting the frame assembly (B) on its side as shown in the figure.
2000-sheet dual input (TTM)—media feed unit assembly removal (tray 4)
1. Remove the media tray 2 assembly.
2. Remove the tray module left cover. See
page
4-164.
3. Remove the TTM media tray 3 assembly. See
removal" on page
4. Remove the TTM media tray 4 assembly. See
removal" on page
5. Remove the tray 4 media transport assembly. See
assembly removal" on page
6. Disconnect the two connectors from the media feed unit assembly (A).
4-176
MFP Service Manual
"2000-sheet dual input (TTM)– tray module left cover removal" on
4-168.
4-167.
4-172.
"2000-sheet dual input (TTM)–TTM media tray 3 assembly
"2000-sheet dual input (TTM)–TTM media tray 4 assembly
"2000-sheet dual input (TTM)–TTM tray 4 media transport