Sensor (Tray 3 Feed-Out) Late Jam - Lexmark X940e Service Manual

7510-XXX
Step
7 Check the MPF/transport drive motor for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer motor tests.
4. Touch MPF/transport drive motor.
Does the above component operate properly?
8 Check the MPF/transport drive motor for proper connection.
Is the above component properly connected?
9 Perform a print test.
Does the error continue?

243.00 Sensor (tray 3 feed-out) late jam

Step
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media size setup.
Does the media size, in use, match the size set for
tray 3?
3 Check the feed roll, separation roll, and pick roll for
media tray 3.
Are the above components free of excess wear and
contamination?
4 Check the media position.
Does the media touch the sensor (tray 3 feed-out)?
2-54
MFP Service Manual
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Check
Yes
Go to step 9. Skip to step 8.
Replace the MPF / Replace the
transport drive connection.
motor .
"MPF /
Go to
transport drive
motor assembly
removal" on
page 4-102.
Replace the lower Problem solved.
printer engine card
assembly.
Go to "Lower
printer engine
card assembly
removal" on
page 4-77.
Yes
Replace the Go to step 2.
damaged media with
new.
Go to step 3. Replace the media,
or change the media
size setup.
Go to step 4. Clean or replace the
feed roll, separating
roll, or pick roll.
Go to
removal" on
page
"Separation roll
removal" on
page
"Pick roll removal"
on page
Remove the media. Go to step 5
No
No
"Feed roll
4-103,
4-105, and
4-104.