7510-XXX
Printer left door assembly removal
1. Remove the rear cover assembly. See
2. Remove the rear left middle cover. See
3. Remove the MPF feed unit assembly. See
4. Remove the screw securing the connector access cover (A) to the machine.
5. Remove the connector access cover (A).
6. Disconnect the three connectors from the printer left door assembly (B).
7. Gently pull the harnesses through the hole in the machine frame.
8. Open the printer left door assembly (B).
9. Remove the front left cover. See
10. Remove the safety screw from the machine.
11. Detach the safety arm (C) from the machine.
12. Remove the C-clip from the machine.
13. Remove the support arm (D) from the machine.
14. Lower the printer left door assembly (B) to an approximate 75° angle as shown in the graphic.
15. Lift the printer left door assembly (B) up to remove it from the machine.
16. Remove the printer left door assembly (B).
4-26
MFP Service Manual
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"MPF feed unit assembly removal" on page
Connectors
"Front left cover removal" on page
4-5.
4-6.
A
4-9.
4-8.