Lexmark X940e Service Manual page 148

7510-XXX
Error code or
message
991.11
Service finisher
error
991.12
Service finisher
error
991.13
Service finisher
error
992.00
Service finisher
error
992.01
Service finisher
error
Close cover F
Close door A
Close door B
Close door C
Close door D
Close door E
Close door G
Close door J
Close
surface H
2-34
MFP Service Manual
Error contents
Booklet stapler error
Communication error with
booklet controller card
assembly
Booklet unit maker error
Sensor (de-curler clutch HP)
late error
Sensor (de-curler clutch HP)
lag error
Bridge unit cover is open.
Printer left door open.
Duplex left door assembly
open.
Printer left lower door
assembly open
1TM, 3TM or TTM left door
assembly open
Printer front door assembly
open
Finisher front door open.
Transfer belt access door
open.
Eject cover open.
Description/Action
The booklet stapler unit has failed.
Refer to the Finisher Service Manual.
A communication error has occurred with the
booklet controller card assembly and the finisher
controller card assembly.
Refer to the Finisher Service Manual.
Booklet set recovery was detected too many times
for the same job. Perform a POR.
Refer to the Finisher Service Manual.
The sensing area of the sensor (de-curler cam HP)
is not interrupted within the specified time after the
de-curler roll assembly (nip) starts moving to the
home position.
Refer to the Finisher Service Manual.
The sensing area of the sensor (de-curler cam HP)
remains interrupted within the specified time after
the de-curler roll assembly (nip) starts moving from
the home position.
Refer to the Finisher Service Manual.
The bridge unit assembly cover is open.
Refer to the Finisher Service Manual.
The printer left door assembly is open.
Go to "Printer left door open" on page
The Duplex left door assembly is open.
Go to "Duplex left door assembly open" on
page 2-166.
The printer lower left door assembly is open.
Go to "Printer left lower door assembly open" on
page 2-173.
The 1TM, 3TM or TTM tray left door assembly is
open.
Go to "1TM, 3TM or TTM left door assembly
open" on page 2-165.
Printer front door assembly is open.
Go to "Printer front door assembly open" on
page 2-171.
The finisher front door is open.
Refer to the Finisher Service Manual.
The transfer belt access door is open.
"Printer front door assembly open" on
Go to
page 2-171.
The finisher eject cover is open.
Refer to the Finisher Service Manual.
2-172.