Sensor (Registration) Late Jam (Feeding From The Mpf) - Lexmark X940e Service Manual

Step
8 Check the tray module drive motor for proper
connection.
Is the above component properly connected?
9 Perform a print test.
Does the error continue?
10 Perform a print test.
Does the error continue?

250.00 Sensor (registration) late jam (feeding from the MPF)

Step
1 Check the media condition.
Is the media in the MPF tray crumpled or damaged?
2
Check the media size setup.
Does the media size in use match the size set for MPF tray?
3 Check the media position.
Does the media touch the sensor (registration)?
Check
Check
Yes
Replace the tray
Replace the
module drive motor .
connection.
Go to "2000-sheet
dual input (TTM)–
tray module drive
motor assembly
removal" on
page 4-200 or
"2000-sheet dual
input (TTM)–tray
module drive motor
assembly removal"
on page 4-200.
Replace the 1TM Problem solved.
controller card
assembly or the 3TM
controller card
assembly or the TTM
controller card
assembly.
Go to "1X 500-
sheet drawer
(1TM)–1TM
controller card
assembly removal"
on page 4-249"3X
500-sheet drawer
(3TM)–3TM
controller card
assembly removal"
on page 4-228 or
"2000-sheet dual
input (TTM)–TTM
controller card
assembly removal"
on page 4-202.
Go to step 10.
Replace the lower Problem solved.
printer engine card
assembly.
"Lower
Go to
printer engine card
assembly removal"
on page 4-77.
Yes
Replace the media Go to step 2.
with new; ensure it
is dry.
Go to step 3. Replace the media
or change the
media size setup.
Remove the Go to step 4.
media.
Diagnostic information
7510-XXX
No
No
2-61