Lexmark X940e Service Manual page 141

Error code or
message
905.02 Marking device Xerographic
error
Service engine
error
905.03 Marking device other1 error
Service engine
error
905.04 Marking device paper
handling error
Service engine
error
905.05 Marking device other2 error
Service engine
error
907.00 Printhead polygon mirror
motor error
Printhead error
907.01 SOS internal error
Printhead error
907.02 SOS internal error
Printhead error
907.03 SOS internal error
Printhead error
907.04 SOS internal error
Printhead error
907.05 Printhead control error
Printhead error
908.00 Waste toner full error
Service engine
error
911.00 24V LVPS cooling fan error
Service engine
error
911.01 Transfer belt drive motor
cooling fan error
Service engine
error
Error contents Description/Action
Internal processing error occurred in printer engine.
Go to "905.02 Marking device Xerographics
error" on page 2-139.
Internal processing error occurred in printer engine.
Go to "905.03 Marking device other1 error" on
page 2-140.
Internal processing error occurred in printer engine.
"905.04 Marking device paper handling
Go to
error" on page 2-140.
Internal processing error occurred in printer engine.
Go to "905.05 Marking device other2 error" on
page 2-140.
The printhead polygon mirror motor has failed or
does not rotate at the specified speed.
Go to "907.00 Printhead polygon mirror motor
error" on page 2-140
The interval of the printhead start of scan Y signals
exceed the specified value.
Go to "907.01 SOS internal error" on page
The interval of the printhead start of scan M signals
exceed the specified value.
Go to "907.02 SOS internal error" on page
The interval of the printhead start of scan C signals
exceed the specified value.
Go to "907.03 SOS internal error" on page
The interval of the printhead start of scan K signals
exceed the specified value.
Go to "907.04 SOS internal error" on page
Operation error of the printhead ASIC in the printer
engine. An error occurred during the read/write test.
Go to "907.05 Printhead control error" on
page 2-142.
After the sensor (waste toner full) turned on, the
pixel count exceed the specified value.
Go to "908.00 Waste toner full error" on
page 2-143.
When the 24V LVPS cooling fan was operating, fan
lock was detected for more than 30 seconds.
Go to "911.00 24V LVPS cooling fan error" on
page 2-143.
When the transfer belt drive motor cooling fan was
operating, fan lock was detected for more than 30
seconds.
Go to "911.01 Transfer belt drive motor cooling
fan error" on page 2-144.
Diagnostic information
7510-XXX
2-141.
2-141.
2-142.
2-142.
2-27