Adf Left Cover Handle Removal - Lexmark X940e Service Manual

7510-XXX

ADF left cover handle removal

1. Open the ADF left cover assembly.
2. Remove the ADF left cover media guide. See
3. Remove the ADF left cover media guide. See
4. Remove the ADF feed/pick assembly. See
5. Remove the sheet through actuator. See
6. Remove the document set actuator. See
7. Remove the pick roll position motor assembly. See
Note: The pick roll position motor assembly does not need to be completely removed; it can be allowed to hand
loosely out of the way.
8. Remove the two screws securing the plastic harness guide (A) to the assembly.
Note: The plastic harness guide (A) does not need to be completely removed; it can be allowed to hand loosely out
of the way.
9. Remove the spring (B) from the ADF left cover handle (C).
10. Remove the two screws securing the front bracket (D) to the assembly.
11. Remove the front bracket (D).
12. Remove the two screws securing the rear bracket (E) to the assembly.
13. Remove the rear bracket (E).
Note: The grounding plate (F) will become detached.
14. Gently pry or push the ADF left cover handle (C) from the front and rear mounting points in the assembly.
15. Remove the ADF left cover handle (C).
4-130
MFP Service Manual
"ADF left cover media guide removal" on page
"ADF left cover media guide removal" on page
"ADF feed/pick roll assembly removal" on page
"Sheet through actuator removal" on page
"Document set actuator removal" on page
"Pick roll position motor assembly removal" on page
4-141.
4-141.
4-139.
4-137.
4-140.
4-141.