7510-XXX
Inverter solenoid assembly removal
1. Open the ADF left cover assembly.
2. Remove the ADF front cover assembly. See
3. Loosen the set screw securing the damper (A).
4. Remove the damper (A).
5. Disconnect the connector from the inverter solenoid assembly (B).
6. Remove the screw securing the inverter solenoid assembly (B).
7. Remove the inverter solenoid assembly (B).
8. Remove the plunger from the inverter lever (C).
Note: Before reinstalling the inverter solenoid assembly (B), ensure that the plunger is properly inserted into the
inverter solenoid assembly (B) and attached to the inverter lever (C).
4-136
MFP Service Manual
"ADF front cover assembly removal" on page
B
C
Plunger
Set
screw
A
Connector
Front
4-128.