Lexmark X940e Service Manual page 651

Step
3 Analyze the fine skew setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Cycle result values
Locate the following new values for the following settings:
Patch-B in
Patch-B out
Is the value for both of the above settings a "4"?
4 Perform the skew rough setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew rough setup
Does the above test pass?
Check Yes
Go to step 4. Go to step 6.
Go to step 5. Go to step 6.
Repair information
7510-XXX
No
4-259