K Erase Lamp Assembly Removal - Lexmark X940e Service Manual

12. Gently raise the rear of the appropriate CMY erase lamp assembly (B) to detach the mounting hook from the
machine.
13. Remove the appropriate CMY erase lamp assembly (B).

K erase lamp assembly removal

Warning: Ensure the transfer belt assembly unit is removed, or damage will occur.
1. Remove the front left cover. See
2. Remove the waste toner cartridge cover. See
3. Remove the waste toner cartridge sensor assembly. See
on page 4-39.
4. Remove the sensor (waste toner cartridge full). See
page 4-40.
5. Remove the transfer belt unit assembly. See
6. Remove the inner cover. See
7. Raise the transfer belt lift handle (A) to its upper-most position.
8. Disconnect the connector from the K erase lamp assembly (B).
9. Release the harness from the clamp.
10. Remove the screw securing the bracket (C) to the machine.
11. Lower the transfer belt lift handle (A) to its lower-most position.
12. Access to the rear mounting hook on the K erase lamp (B) can be gained by reaching into the transfer belt unit
opening from the right side of the machine.
A
C
Connector
Mounting hook
"Front left cover removal" on page
"Transfer belt unit assembly removal" on page
"Inner cover removal" on page
B
4-9.
"Waste toner cartridge cover removal" on page
"Waste toner cartridge sensor assembly removal"
"Sensor (waste toner cartridge full) removal" on
4-43.
7510-XXX
4-39.
4-16.
4-63
Repair information