7510-XXX
Step
2
Perform the center setup:
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Center setup
Does the above test pass?
3
The image density sensor is not properly set in the center
position. Ensure the image density is placed in the center
position.
Is the image density placed in the center position.
4-268
MFP Service Manual
Check
Yes
Move the image
Go to step 3.
density sensor
back to its original
position.
The color
registration
(RegCon)
procedure is now
complete.
Go to step 2.
Repeat step 3.
No