Lexmark X940e Service Manual page 145

Error code or
message
980.02 Communication error
between printer and RIP card
Service device
assembly
comm
980.03 Communication error with
finisher controller card
Service finisher
assembly
comm
981.00 Sensor (stacker bin level 1)
late error
Service finisher
error Sensor (stacker bin level 2)
late error
981.01 Stacker bin upper limit error
Service finisher
error
981.02 Stacker bin lower limit error
Service finisher
error
982.00 Sensor (front tamper HP) late
error
Service finisher
error
982.01 Sensor (front tamper HP) lag
error
Service finisher
error
983.00 Sensor (rear tamper HP) late
error
Service finisher
error
983.01 Sensor (rear tamper HP) lag
error
Service finisher
error
984.00 Sensor (punch unit HP) late
error
Service finisher
error
984.01 Sensor (punch unit HP) lag
error
Service finisher
error
Error contents Description/Action
A communication error has occurred with the RIP
card assembly and the upper printer engine card
assembly and the.
Go to "980.02 Communication error between
printer and RIP card assembly" on page
A communication error has occurred with the upper
printer engine card assembly and the finisher
controller card assembly.
Go to "980.03 Communication error with finisher
controller card assembly" on page
The sensing area of the sensor (stacker bin level 1)
or Sensor (stacker bin level 2) is not interrupted
within the specified period after the stacker bin
starts rising.
Refer to the Finisher Service Manual.
The sensing area of the sensor (stacker bin upper
limit) is not interrupted when the stacker bin raises
to its uppermost limit.
Refer to the Finisher Service Manual.
The stacker bin lowers beyond the specified lower
limit within the specified time.
Refer to the Finisher Service Manual.
The sensing area of the sensor (front tamper HP) is
not interrupted when the front tamper starts moving
to the home position.
Refer to the Finisher Service Manual.
The sensing area of the sensor (front tamper HP)
remains interrupted within the specified time after
the front tamper starts moving from the home
position.
Refer to the Finisher Service Manual.
The sensing area of the sensor (rear tamper HP) is
not interrupted when the rear tamper starts moving
to the home position.
Refer to the Finisher Service Manual.
The sensing area of the sensor (rear tamper HP)
remains interrupted within the specified time after
the rear tamper starts moving from the home
position.
Refer to the Finisher Service Manual.
The sensing area of the sensor (punch unit HP) is
not interrupted during the specified time after the
punch unit starts moving to the home position.
Refer to the Finisher Service Manual.
The sensing area of the sensor (punch unit HP)
remains interrupted within the specified time after
the punch unit starts moving from the home
position.
Refer to the Finisher Service Manual.
Diagnostic information
7510-XXX
2-164.
2-164.
2-31