Mazda 1990 323 Workshop Manual Supplement page 95

I
TRANSAXLE AND TRANSFER UNIT
53
. .
1. Wheel and tire
2. Splash shield
3. Air hose and air cleaner assembly
4. Battery
5. Battery carrier
6. Speedometer cable
7. Shift cable
8. Neutral switch connector
9. Back-up light switch connector
10. Differential lock motor connector
11. Bolt
12. Control cable
13. Undercover
14. Propeller shaft
Removal Note ,,,..,,.................... page J3-17
15. Integrated stiffener
16. Crossmember
17. Exhaust pipe
18. Tie-rod end
Removal Note . . . . . . . . . . . . . . . . . . . . . . . . . . . page J3-17
19. Stabilizer
20. Joint shaft
21. Driveshaft
Removal Note ,..,,...................... page J3-17
22. Center differential lock motor
Removal Note ,,...,,..,,.....,,......... page J3-18
23. Starter
24. Engine mount member
Removal Note . . . . . . . . . . . . . . . . . . . . . . . . . . . page J3-19
25. Engine mount No.2
26. Clutch release cylinder and clutch pipe
Removal Note ,..,......,................ page J3-19
27. Transaxle and transfer carrier
Removal Note . . . . . . . . . . . . . . . . . . . . . . . . . . . page J3-19
03UOJ3-020
03UOJ3-02
Removal note
Propeller shaft
Caution
l
Do not mark with a punch.
1. Mark the companion flange and the front yoke.
2. Mark the companion flange and the rear yoke.
3. Remove the propeller shaft.
I
03UOKX-159
Tie-rod end
1. Remove the cotter pin.
Caution
l
Do not damage the dust boot.
2. Loosen the nut and disconnect the tie-rod end with the SST.
Driveshaft
Caution
l
Do not damage the ball joint dust boot.
1. Remove the clinch bolts from the lower arm ball joints.
2. Pull the lower arms downward to separate them from the
knuckles.
J3-17