Mazda 1990 323 Workshop Manual Supplement page 104

J3
TRANSAXLE AND TRANSFER UNIT
03UOJ3.048
Note
l
Tap in until the oil seal installer contacts the case.
l
Coat the oil seal lip with transaxle oil.
11. Tap the new oil seal into the transaxle case with the SST.
-J
12. Replace the driveshaft end clip with a new one. Insert the
driveshaft with the end-gap of the clip facing upward.
13. Install the joint shaft.
Tightening torque:
42-62 N-m (4.3-6.3 m-kg, 31-46 ft-lb)
14. install the lower arm ball joint to the knuckle and tighten.
Tightening torque:
43-54 N#m (4.4-5.5 m-kg, 32-40 ft-lb)
15. Install the tie-rod end to the knuckle and tighten it.
Tightening torque:
29-44 N&m (3.0-4.5 m-kg, 22-33 f&lb)
16. Install a new gasket, and the drain plug, and add the speci-
fied oil from check plug port.
Tightening torque:
39-59 N-m (4.0-6.0 m-kg, 29-43 ft-lb)
J3-26