Mazda 1990 323 Workshop Manual Supplement page 412

K2
TRANSAXLE AND TRANSFER UNIT
1. install the control valve body assembly.
Tightening torque:
11-15 N,m (1.1-1.5 m-kg, 8.0-11 ft-lb)
2. Apply ATF to a new O-ring and install it onto the solenoid
connector.
3. Install the solenoid connector into the transaxle case.
03UOK2-225
I
03UOK2-22t
03UOK2-227
UP SIDE
I
DOWN
SIDE
4. Install the throttle cable to the throttle cam.
5. Install the control valve body cover along with a new gasket.
Tightening torque:
6. Align the marks, and slide the oil cooler hose onto the oil
cooler pipe until it is fully seated against the ridge.
7. Install the hose clamp onto the hose at the center of the
mark and at the angle shown.
8. Verify that the hose clamp does not interfere with any other
parts.
9. Pour in ATF and with the engine idling, check the ATF lev-
el and check for leaks. (Refer to page K2-134.)
10. Drive the vehicle and check the shift points, shift schedule,
and shift shock. (Refer to Road test; page K2-127.)
I I
03UOK2-228
K2-236