Mazda 1990 323 Workshop Manual Supplement page 162

53
TRANSAXLE AND TRANSFER UNIT
r
03UOJ3-16t
1
03UOJ3-16
r
03UOJ3-I 7
03UOJ3-17
3. Install the bolt.
Locknut
1. Shift to 1 st gear.
2. Lock the primary shaft with the SST.
3. Tighten new locknuts on the primary and secondary shafts.
Tightening torque:
128-206 N*rn (13.0-21 m-kg, 94-152 ft-lb)
4. Stake the locknuts to the groove.
Primary 5th gear
Note
l
After installation, move the shift rod to verify that
the gear change operation is smooth.
1. Shift to neutral and install the roll pin.
Rear Cover
Note
l
Clean the contact surfaces before applying sealant.
I, Apply sealant to the transaxle case and rear cover.
2. Install the rear cover.
Tightening torque:
7.8-11 N-m (0.8-1.1 m-kg, 5.8-8.0 ft-lb)
Center Differential Lock motor
1. Install the center differential lock motor.
Tightening torque:
19-25 N,m (1.9-2.6 m-kg, 14-19 ft-lb)
J3-84