J3
TRANSAXLE
AND TRANSFER
UNIT
I
03UOJ3-134
OUTER
RACE
SELECTOR
I
03UOJ3-135
03UOJ3-136
Primary and secondary
shaft gear
1. Install the primary and secondary shaft bearing outer races
into the transaxle case (shims removed).
2. As shown in the figure, put the outer races into the SST.
Note
l
Turn the selector to eliminate the gap indicated
by
the arrow in the figure.
3. Set the SST (selectors) in place.
4. Mount the primary and secondary shaft gear assemblies
onto the SST (selectors).
5. Set the SST (collars) between the transaxle case and the
clutch housing, and install the SST (bolts), and tighten to
the specified torque.
Tightening
torque:
37-52
N#m (3.8-5.3
m-kg, 27-38
ft-lb)
6. To seat the bearings, mount the SST (bar) on parts (A) and
(B) of the SST (selectors), and turn the selector so the gap
is enlarged.
Move the bars by hand until the selector can no longer be
turned, and then turn it in the reverse direction until the gap
is eliminated.
--'
J3-74