Mazda 1990 323 Workshop Manual Supplement page 456

K2
TRANSAXLE AND TRANSFER UNIT
OIL COOLER
OIL COOLER
Removal / Inspection / Installation
Remove in the order shown in the figure.
Inspect all parts and repair or replace as necessary.
Install in the reverse order of removal, referrino to
Installation Note.
24-35 (2.4-3.6, 17-26)
YELLOW MA
YELLOW MARK
P
WHITE MARK
0
REPLACE
24-35 (2.4-3.6, 17-26)
N.m (m-kg, ft-lb)
1. Connector bolts
Inspect for clogging
2. Packing
3. Oil pipes
Inspect for damage or cracks
I
UP SIDE
03UOKX-503
K2-280
4. Oil hoses
Inspect for damage or cracks
Installation
note . . . . . . . . . . . . . . . . . . . . . . page K2-253
5. Hose clamps
6. Radiator
Service
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section E
Installation note
Oil hose
1. Align the marks, and slide the oil cooler hose onto the oil
cooler pipe until it is fully seated against the ridge.
2. Install the hose clamp onto the hose at the center of the
mark and at the angle shown.
3. Verify that the hose clamp does not interfere with any other
parts.