53
TRANSAXLE
AND TRANSFER
UNIT
03UOJ3-15
0
03UOJ3-161
3
03UOJ3-16'
9
03UOJ3-16:
Assembly
note
Oil seal (Speedometer
driven
gear assembly)
1. Install the new oil seal with a suitable pipe.
Pipe diameter:
16mm (0.629 in)
Speedometer
driven gear
1. Install the new roll pin as shown in the figure.
Primary shaft assembly, secondary shaft assembly, front
and center differential,
idler gear assembly
Caution
l
Do not incision the hands to install time.
l
Do not damage the oil seal.
1. Lean the clutch housing.
2. Install the front and center differential assembly, idler gear,
and center differential shift fork assembly.
3. Hold up the front and center differential assembly and idler
gear assembly so that primary shaft and secondary shaft
can be removed.
4. Align the shift forks (lst/2nd and 3rd/4th) as shown.
5. Install the primary shaft assembly, secondary shaft assem-
bly, and shift fork assembly.
6. Verify that the gears are properly engaged.
J3-82