Mazda 1990 323 Workshop Manual Supplement page 444

K2
TRANSAXLE AND TRANSFER UNIT
03UOKX-461
03UOK2-271
03UOK2-27
03UOK2-27
19. Install the retaining plate.
20. Install the snap ring.
21. Check the low and reverse brake clearance.
(1) Measure the clearance between the snap ring and the
low and reverse brake retaining plate.
(2) If the clearance is not within specification, adjust it by
selecting a proper retaining plate.
Low and reverse brake clearance:
2.1-2.4mm (0.083-0.094 in)
Retaining plate sizes
mm (in)
6.8 (0.268) 7.0 (0.276)
7.2 (0.283)
7.4 (0.291)
7.6 (0.299) 7.8 (0.307)
22. Check the low and reverse brake operation by applying
compressed air through the fluid passage as shown in the
figure.
Air pressure: 392 kPa (4.0 kg/cm2, 57 psi)
23. Install the wave washer.
24. Install the one-way clutch.
(1) Hold the one-way clutch horizontally.
(2) Install it by turning the carrier hub assembly counter-
clockwise.
(3) Install the snap ring.
25. Install the servo to the transaxle case.
(1) Install the servo spring and servo.
(2) Compress the servo with the
SST.
(3) Install the snap ring.
(4)
Remove the
SST.
(5) Install the piston stem.
K2-268