Mazda 1990 323 Workshop Manual Supplement page 165

TRANSAXLE AND TRANSFER UNIT
J3
1. Transaxle and transfer unit
Installation
Note . . . . . . . . . . . . . . . . . . . . . . . . page J3-87
2. Clutch release cylinder and clutch pipe
3. Engine mount No.2
4. Engine mounting member
Installation Note . . . . . . . . . . . . . . . . + . . . . . . . page J3-87
5, Starter
6. Center differential lock motor
7. Driveshaft
Installation
Note . . . . . . . . . . . . . . . . . . . . . . . . page J3-88
8. Joint shaft
9. Stabilizer
Installation Note . . . . . . . . . . . . . . . . . . . . . . . . page J3-88
10. Tie-rod end
Installation Note . . . . . . . . . . . . . . . . . . . . . . . . page J3-89
11. Exhaust pipe
12. Crossmember
13. Integrated stiffener
14. Propeller shaft
Installation
Note . . . . . . . . . . . . . . . . . . . . . . . . page J3-89
15. Undercover
16. Control cable
Installation Note ,......,..,.,,....,..... page J3-89
17. Bolt
18. Differential lock motor connector
19. Back-up light switch connector
20. Neutral switch connector
Installation
Note . . . . . . . . . . . . . . . . . . . . . . . . page J3-89
21. Shift cable
22. Speedometer cable
Assembly
Note. . . . . . . . . . . . . . . . . . . . . . . . . page J3-90
23. Battery carrier
24. Battery
25. Air hose and air cleaner assembly
26. Splash shield
27. Wheel and tire
03UOJ3-175
I
03UOJ3-176
1
:I
L
03UOJ3-177
. . . _
03UOJ3-17 ' 0
Installation Note
Transaxle and transfer carrier
1. Mount the transaxle to the engine.
Tightening torque:
55-80 Nern (5.6-8.2 m-kg, 41-59 ft-lb)
Engine mounting member
1. Tighten the bolts as shown.
Tightening torque:
A 37-52 N,m (3.8-5.3 m-kg, 27-38 f&lb)
B 64-89 N#m (6.5-9.1 m-kg, 47-66 ft-lb)
2. Tighten engine mount No.4 nuts.
Tightening torque:
66-93 N.m (6.8-9.5 m-kg, 49-68 ft-lb)
J3-87