Mazda 1990 323 Workshop Manual Supplement page 385

TRANSAXLE AND TRANSFER UNIT
K2
CONTROL VALVE BODY (DISASSEMBLY / INSPECTION)
Disassembly / Inspection
i/
Caution
l
Be especially careful when handling the control valve because it consists of the most precise
and delicate parts of the transaxle.
l
Neatly arrange the removed parts to avoid confusing the similar parts.
l
Clean the removed parts with cleaning solvent, and dry them with compressed air. Clean out
all holes and passages with compressed air.
1. Disassemble in the order shown in the figure, referring to
Disassembly Procedure.
2. Inspect all parts and repair or replace as necessary.
1. 1-2 solenoid valve
Inspection , . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page K2-
9. Front premain rear gasket
10 Orifice check valve and spring
. . . - , , ,_ _ _,-
--
2. Oil strainer
3. 2-3 solenoid valve
Inspection
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page K2-
4. Oil strainer
5. Bolts
6. Front control body
Inspect for clogging and damage
7. Frontlpremain front gasket
8. Permain separator
11.
rremarn conrror ooay
Disassembly I Inspection I
Assembly
. . . . . . . . . . . . . . . . . . . . . . page K2-214
12. Orifice check valve and spring
13. Orifice check valve and spring
14. Throttle relief ball and spring
15. Premainlmain front gasket
16. Main separator
K2-209