TRANSAXLE
AND TRANSFER
UNIT
03UOJ3-130
CLuTcr-i
ii0Us1~G
03UOJ3-131
Adjust shim thickness
mm (in)
0.10 (0.003)
0.20 (0.008)
0.25 (0.010)
0.30 (0.012)
0.35 (0.014)
0.40 (0.016)
0.45 (0.018)
0.50 (0.020)
0.55 (0.022)
0.60 (0.024)
0.65 (0.026)
0.70 (0.028)
0.75 (0.030)
0.80 (0.032)
0.85 (0.034)
0.90 (0.035)
0.95 (0.037)
1 .oo (0.039)
1.05 (0.041)
1.10 (0.043)
1.15 (0.045)
1.20 (0.047)
03UOJ3-13:
3. Set the idler gear assembly into the clutch housing.
4. Turn the idler gear assembly to seat the bearing.
5. Install the bearing outer race to the idler gear assembly.
6. Measure from the top of the bearing outer race to the clutch
housing.
J
Caution
l
The number of shims used must not exceed two.
7. Select the shim as follows.
(a) Subtract the bearing height (Step 6) from the depth of
the bearing bore (Step 2).
(b) Add 0.17mm (0.0067 in) to (a).
(c) Add 0.22mm (0.0087 in) to (a).
(d) Select the shim in the range between (b) and (c) from
the table.
J3-72