J3
TRANSAXLE
AND TRANSFER
UNIT
03UOJ3-153
Tightening
torque:
03UOJ3.15
03UOJ3-155
5. Connect the SST to the primary shaft gear.
6. Check the primary shaft preload.
Preload:
0.10-0.25
N*m (1.0-2.5
cm-kg, 0.87-2.18
in-lb)
7. Remove the SST, transaxle case, primary shaft gear and
front and center differential assembly.
8. Install the secondary shaft gear and transaxle case, and
tighten to the specified torque.
37-52
N-m (3.8-5.3
m-kg, 27-38
ft-lb)
9. Check the secondary shaft preload with the SST.
Preload:
0.3-0.4
N*m (3.0-4.3
cm-kg, 2.8-3.7
in-lb)
10. Remove the SST, transaxle case and secondary shaft gear.
Assembly
note
Oil seal (Front and center differential)
Caution
l
Apply transaxle oil to the outer edge of the oil seal.
1. Install the new oil seal with the SST.
-,
Bearing outer race (Idler gear)
1. Install the bearing outer race with the SST.
Bearing outer race (Front and center differential)
1. Install the bearing outer race with the SST.
03UOJ3-156
J3-78