Mazda 1990 323 Workshop Manual Supplement page 426

1990 mazda 323 4-wheel drive workshop manual supplement

Hide thumbs Also See for 1990 323:

Table of Contents

AND TRANSFER

f) Place the SST atop the drive pinion model;

then set the

body atop the gauge

g) Place the feeler of the dial indicator

so that it contacts

where the side bearing

is installed

in the carrier.

ure the lowest position

on both the left and right sides.

h) Add the two (left and right) values obtained

by the meas-

taken in step g, and divide the total by 2.

are available

in increments

i) If it is not within specification,

adjust the pinion height by

of a spacer.

for the pinion

that the installation

1. Install the spacer.

2. Press the rear bearing

on with the SST.

3. Apply a light coat of grease to the end face of the compan-

Show Quick Links

Chapters

Table of Contents