ELECTRONIC
SYSTEM
COMPONENTS
K2
OSUOKX-14
03UOKX-148
03UOKX-149
SPEED SENSOR
Inspection
1. Connect a voltmeter
between the terminal
1 P and a ground
as shown.
2. Turn the ignition
switch ON.
3. Remove
the speedometer
cable from the transmission.
4. Slowly turn the speedometer
cable one turn.
5. Verify that
approx. 7V
is shown 4 times.
6. If not correct,
check the speedometer
and cable.
SOLENOID VALVE
Inspection
1. Disconnect
the solenoid
valve connector.
2. Measure
resistance
between each terminal
and a ground.
Resistance:
13-27Q
Note
l
1-2 shift solenoid valve: A
l
2-3 shift solenoid valve: B
l
3-4 shift solenoid valve: C
l
Lockup solenoid valve: D
3. If not correct,
check the wiring for an open-or
short-circuit.
Replace
the solenoid
valve.
Continuity
1. Disconnect
the 20-pin connector
from the EC-AT control unit.
2. Check continuity
between terminals
2E, 2G, 21, and 2K, and
a ground.
3. If not correct,
check
the wiring for an open-circuit.
03UOKX-150
K2-143