K2
TRANSAXLE
AND TRANSFER
UNIT
I
03UOK2-323
I
,
03UOK2-302
03UOKX-498
I
/
03UOK2-30:
03UOK2-30
Engine
mounting
member
1. Tighten
the bolts as shown.
Tightening
torque:
A 37-52
N.m (3.8-5.3
m-kg,
27-38
ft-lb)
B 64-89
N-m (6.5-9.1
m-kg,
47-66
ft-lb)
2. Tighten
the engine
mount
No.4 nuts.
Tightening
torque:
66-93
N.m (6.8-9.5
m-kg,
49-68
ft-lb)
Driveshaft
Caution
l
Do not damage
the oil seal.
l
After installation,
pull the front hub outward
to verify
that the driveshaft
is secured.
1. Replace
the clips at the ends of the driveshafts
and joint
shaft with new ones.
2. Push the driveshafts
into the differential
with the groove of
clips upward.
Note
l
Apply
ATF to the oil seal lip.
3. Install the driveshaft.
4. Tighten
the joint shaft mounting
bolts in the order shown.
Tightening
torque:
42-62
N-m (4.3-6.3
m-kg,
31-46
ft-lb)
K2-278