Mazda 1990 323 Workshop Manual Supplement page 328

K2
TRANSAXLE AND TRANSFER UNIT
TRANSAXLE AND TRANSFER UNIT (DISASSEMBLY)
Precaution
General Notes:
1. Disassemble the transaxle in a clean area (dustproof work space) to prevent entry of dust into the
mechanisms.
2. Inspect the individual transaxle components in accordance with the QUICK DIAGNOSIS CHART
during
disassembly. (Refer to page K2-21.)
3. Use only plastic hammers when applying force to separate the light alloy case joints.
4. Never use rags during disassembly; they may leave particles that can clog fluid passages.
5. Several parts resemble one another; organize them so that they do not get mixed up.
6. Disassemble the control valve assembly and throughly clean it when the clutch or brake band has burned
or when the ATF has degenerated.
Cleaning Notes:
1. Clean the transaxle exterior thoroughly with a steam cleaner or cleaning solvents before disassembly.
2. Clean the removed parts with cleaning solvent, and dry with compressed air. Clean out all holes and pas-
sages with compressed air, and check that there are no obstructions.
3. Wear eye protection when using compressed air to clean components.
03UOK2-110
Components
03UOK2-11
1. Torque converter 4. Oil pan and gasket
8. Control valve body assembly
Inspection
. . . . page K2-167 5. Oil strainer
Disassembly I Inspection
2. Oil pump shaft
6. Inhibitor switch
. . . . . . . . . . . . . . . . ..a page K2-209 -J
3, Oil level gauge and oil filler
Inspection . . . page K2-140
Assembly
. . . . . page K2-225
tube
Adjustment . . . page K2-141
9. Throttle cable
7. Oil pan and gasket
IO. Oil pump and gasket
K2-152