Raytheon NautoPilot NP 5100 Operator's Manual page 88

Table 11
Figure 39/1
Figure 39/2
Figure 39/3
Figure 39/4
Figure 39/5
Figure 39/6
Figure 39/7
Figure 39/8
Figure 39/9
Figure 39/10 Softkey for switching back to the previous display, without a
Figure 39/11 Numerical indication of calculated Drift; the calculation is based
Figure 39/12 Numerical indication of calculated set; the calculation is based
Figure 39/13 Softkey for adjusting an observed drift. This value can be input
4002.DOC010102
OPERATION
NautoPilot 5000 Series
Softkeys for "Position Monitoring" displays
Display, shows the position of a maximum of two GPS receiv-
ers and their relative position to the ship.
The position sensor in use (control function of the Autopilot) is
always in the centre.
Information on heading source and actual heading value.
Set heading value.
For Course Control this display is designated as "Presel.COG"
(Preselected Course Over Ground) after turning the rotary
knob, "Set COG" after releasing the knob (in increments of
1 degree or 1/10 degree -- depends on selected resolution).
For Track Control this display is designated as "Track Course".
For Heading Control this display is designated as "Set Head-
ing".
Touch--icon for switching to a higher resolution for the set
heading value.
Numerical display for the rudder angle in degrees; an arrow
next to this display shows the direction of the rudder angle.
Softkey for switching to a "Setup Dead Reckon" display.
Softkey for switching to the previous display.
Softkeys for changing the selected dead reckoning parameters.
Changes must be acknowledged with a "SET" (a small icon is
displayed after a change has been made, see also Figure 40).
Softkey for copying the calculated set and drift values for the
calculation of a dead reckoning position to the corresponding
adjustable set and drift fields.
These values must be acknowledged with "SET" (after copying)
to become active.
transfer of changed values.
on the values from the position sensor in use.
on the values from the position sensor in use.
from the user and influences the position of "Dead Reckoning"
on the display.
Value range: 00.0kn to 99.9kn
(in increments of 0.1kn).
76
Function
Edition: September 2014