Raytheon NautoPilot NP 5100 Operator's Manual page 128

AS application
HAND
For a switching over to "Heading Control" caused by lost position value,
see section 4.4.6.
4002.DOC010102
NautoPilot 5000 Series
Switching the "Main Steering Switch" into position HAND,
AUTO
switches the Autopilot to "Manual".
No LED for activated control modes will light up.
The mode change is displayed at the top right corner of the
display (Course Ctrl.  Manual).
Note:
Switching the "Main Steering Switch" into position AUTO,
switches the Autopilot to "Heading" again.
Activating a NautoSteer steering device (Tiller AS or Hand-
wheel AS) in combination with an Override Operator Unit AS
switches the Autopilot control mode off.
Observe section 1.4.8.
Note:
Tiller AS
An activation of the Autopilot with the Override Operator Unit
AS (button Autopilot), switches the Autopilot into "Heading
Control".
The lower LED for standby (in "Heading Control" mode) will
light up.
The mode change is displayed at the top right corner of the
display (Course Ctrl.  Override).
Activating a NautoSteer steering device (Tiller AS or Hand-
wheel AS) without an Override Operator Unit AS switches
the Autopilot control mode off.
Observe section 1.4.8.
Tiller
The lower LED for standby will light up yellow.
The mode change is displayed at the top right corner of the
display (Heading Ctrl.  Standby).
OPERATION
or
or
116
Edition: September 2014