Raytheon NautoPilot NP 5100 Operator's Manual page 175

TC Interr No ECDIS
Status
----------------------------------------------
Trck.Ctrl.Interr.
Turn Rate too fast
----------------------------------------------
Turn Rate too fa
Unplausible set heading
change
----------------------------------------------
Unplausible set
Updating software
----------------------------------------------
Updating software
Using SOG for DR
check Speed Sensors
----------------------------------------------
Using SOG for DR
Value not accepted
----------------------------------------------
Value not accepted
WOP IN 3 MIN OR
LESS
----------------------------------------------
WOP in 3 MIN OR
WOP IN 30 SECONDS
OR LESS
----------------------------------------------
WOP in 30 SEC OR
X Software Packages
found.
--------------------------------------
X software Packa
Edition: September 2014
OPERATION
NautoPilot 5000 Series
Message
During Track Control an
ECDIS status failure oc-
curs.
Disconnection of ECDIS
and Autopilot.
Attempt to switch to
Corse Control mode and
turn rate is more than
30 per minute.
Heading change in
Direct heading change
mode.
Vessel turns too fast in
one direction.
Is displayed during a software update.
It is not allowed to operate or to switch off respec-
tive device during an updating procedure (appr.
10min/device).
Speed source for DR
Position is Speed Over
Ground.
Operator input wrong.
3 minutes or less left to turning manoeuvre.
30 seconds or less left to turning manoeuvre.
On connected USB stick more and one software
versions have been detected.
Possible cause
163
Remedy
ECDIS breakdown.
Perform restart of EC-
DIS.
Check value/parameter.
Check operator's input/
adjustment
(see sections 2.3 and
2.3.6.3).
Stabilize heading.
Safety measurement to
prevent a full circle:
Stop direct heading
change mode.
Check Speed Through
Water Sensors.
Check value/parameter.
Check operator's input/
adjustment.
4002.DOC010102
AUTOPILOT