Raytheon NautoPilot NP 5100 Operator's Manual page 31

The set Course Over Ground value is adjusted via the rotary knob and activated either
by pressing the "SET" button or by pressing down the rotary knob.
Please note:
Set Course Over Ground values greater than 6 are not possible (in Course Control
mode).
Several inputs of set Course Over Ground values can be accepted, but only if the last
course change has finished (see Figure 7).
Figure 7:
point of
change
Edition: September 2014
NautoPilot 5000 Series
Explanations for a heading change in Course Control
new courseline
*
Heading change in Heading Control
point of
change
*
One course change of 5 in Course Control
Recommendation:
-- A course change of greater than 5 should be
performed in Heading Control mode. After the
heading change, the Course Control mode can be
activated again.
OPERATION
new courseline
19
AUTOPILOT
4002.DOC010102