Procedure To Switch From "Course Control" Mode To "Heading Control" Mode - Raytheon NautoPilot NP 5100 Operator's Manual

4.3.3

Procedure to switch from "Course Control" mode to "Heading Control" mode

Table 20 Procedure to switch from "Course Control" mode to "Heading Control" mode
Please note:
-- After switching over, the "actual heading" from "Course Control" mode will become
the "set heading" in "Heading Control" mode.
-- It is necessary to observe the Autopilot control function after activation.
4002.DOC010102
OPERATION
NautoPilot 5000 Series
Course Control mode is active.
The mode is displayed at the top right corner of the display
(Course Ctrl.).
Pressing the "Heading" button activates "Heading Control"
mode.
The mode change is displayed at the top right corner of the
display (Course Ctrl.  Heading Ctrl.).
For heading changes in "Heading Control" mode, see
section 4.3.6.
104
Edition: September 2014