Figure 9:
NautoPilot 5000 Series
*
Independent the type of application (Standalone or AS) a switch over to
Course Control is possible only if the control mode is "Heading" before (see section1.4.3).
Edition: September 2014
NautoPilot 5000 Series
Course Control after manual set heading adjustment
Course CTRL
Rotary knob
SET
Select
Course Control
Adjust
Set Course value
Course Change
finished
OPERATION
Actual Heading
Set Course
over Ground
Actual Heading
Set Course
over Ground
Actual Heading
Set Course
over Ground
21
AUTOPILOT
--
Select
*
Course Control
--
Adjust set course
(after "Course Approach")
value with the rotary
knob and
acknowledge this
value either by
pressing the rotary
knob or by pressing
the "SET" button
4002.DOC010102