Switching And Adjusting Rad/Rot - Raytheon NautoPilot NP 5100 Operator's Manual

OPERATION
NautoPilot 5000 Series
AUTOPILOT
2.3.3

Switching and adjusting Rad/RoT

Figure 25: First Display (heading changes with RoT is selected).
1
2 3 4
Heading changes can be performed with a Rate of Turn (RoT) limit or with a limited ra-
dius.
The respective mode can be selected with the "Rad/RoT" softkey. The currently selected
mode is displayed (Figure 25, Pos. 1).
Use the "--" and "+"softkeys (Figure 25, Pos. 2 and 4) to set the value RoT or the value
of the radius.
Each change of value must be acknowledged by pressing the "SET" button, at which
point a small icon is displayed communicating that this change must be acknowledged.
Hold the "--" or "+"softkey to perform a faster change of value
It is not possible to set one of the values to zero.
Value range for RoT: 005/min to 500/min (in increments of 1/min).
Value range for Rad :0.1 NM (nautical mile) to 5.0 NM (in increments of 0.1 NM).
Note:
Rad/RoT is not adjustable in mode Track Control with RAYTHEON Anschütz ECDIS.
55
Edition: September 2014 4002.DOC010102