End Of Track - Raytheon NautoPilot NP 5100 Operator's Manual

1.4.5.1.6

End of Track

Via marking the last track point at the ECDIS, the track controller (Autopilot) recognizes
the end of a track.
An alert is displayed at the top bar of the display (see section 6).
Acknowledge the alert.
An alert is displayed at the top bar of the display (see section 6).
Acknowledge the alert.
Attention:
Before a mode change (e.g. Heading Control) is performed, the ship continues
moving along the extended track with the operating mode "Track Control"!
4002.DOC010102
OPERATION
NautoPilot 5000 Series
Indications
T r a c k E n d x min
two pulses
T r a c k E n d P a s s e d
Change Steering Mode
three pulses
repeated every
7 seconds
T r a c k E n d P a s s e d
38
Comment/Notes
x minutes left to the last track point.
Last track point reached and passed.
Both messages swapping.
The alarm comes up every 7 seconds
until having changed--over to another op-
erating mode, e.g. Heading Control or
manual control (tiller or steering mode
selector switch).
Edition: September 2014