Raytheon NautoPilot NP 5100 Operator's Manual page 16

Table 1
NP 5100
NP 5300
NP 5400
NP 5500
Note:
* For Track Control Category B and C:
In February 2014 the test standard for track control systems IEC 62065 has been re-
vised to edition 2. Please not that only NautoPilot 5400 and 5500 have been adapted to
the latest test standard (introduced with software version E03). NautoPilot 5100 and
5300 are compliant to IEC 62065 edition 1 with software versions E01 and E02.
Standalone application (always with a connected Autopilot Interface, type102--891)
This application may only perform rudder control with an additional Raytheon
Anschütz Autopilot Interface, type 102--891.
Figure 2:
NautoConning
NautoPilot
5000 Series
4002.DOC010102
NautoPilot 5000 Series
Overview NautoPilot types (variants)
Heading Course Weather
Control Control Adaptivity
p
p p
p p
p p
Please note:
This manual contains information for all types and modes.
Some sections are marked for their validity.
Standalone application for the NautoPilot 5000 Series
ECDIS
DUAL CAN bus
OPERATION
Track Track
Control Control
Category B* Category C*
p
p p
p p
p p
Navigation data Status
(serial) data
Raytheon Autopilot
Interface, type 102--891
Single
Rudder control
CAN bus
voltage
(feedback)
(analogue)
4
Cross High
Acceleration Precision
Monitor Controller
p
p p
Analogue
Feedback
Valve
Rudder
Valve
Status data
Alarm data
Edition: September 2014