Direct Heading Change In "Heading Control" Mode - Raytheon NautoPilot NP 5100 Operator's Manual

4.3.6.2

Direct heading change in "Heading Control" mode

Table 24
Direct Heading
Set Heading
Please note:
-- It is necessary to observe the Autopilot control function after heading change.
Edition: September 2014
NautoPilot 5000 Series
Procedure for a direct heading change in "Heading Control"
Mode Heading Control is active.
The mode is displayed at the top right corner of the display
(Heading Ctrl.).
Pressing and turning the rotary knob will change the set
heading value.
This value is displayed in italic and colors are inverted.
125.8
Releasing the rotary knob will transmit the currently dis-
played value to the controller as the new "set heading".
The value is now displayed in non--italics.
125.8
Attention.
The set heading value is changed and the manoeuvre is
executed immediately while pressing and turning the rotary
knob.
OPERATION
111
AUTOPILOT
4002.DOC010102