Raytheon NautoPilot NP 5100 Operator's Manual page 60

Pos.
Figure 20/3
Figure 20/4
Figure 20/5
Figure 20/6
Figure 20/7
Figure 20/5
and 7
Figure 20/8
Information on the change over of NautoPilot Operator Units, see section 5.3.
Information on the test function, see section 2.3.7
Information on the alarm/status message handling, see section 6.
4002.DOC010102
OPERATION
NautoPilot 5000 Series
Designation Remarks
"COURSE" button Activates Course Control mode.
with two LEDs LED (upper, green) indicates the selected
steering mode.
LED (lower, yellow) indicates selected steer-
ing mode, but NautoPilot Operation Unit is
inactive (control from a second NautoPilot
Operator Unit).
"Track" button with Activates Track Control mode.
two LEDs LED (upper, green) indicates the selected
steering mode.
LED (lower, yellow) indicates selected steer-
ing mode, but NautoPilot Operation Unit is
inactive (control from a second NautoPilot
Operator Unit).
Activation of Track Control at the Autopilot is
possible with a generic ECDIS only. Further-
more, it is not possible with an NP5500. If
Track Control cannot be activated the Autopi-
lot, an error message will be displayed.
"DIM" button Adjusts brightness of illumination and display.
See also section 5.3 for dimming
active/inactive NautoPilot Operator Units.
"ACK" button with Acknowledges alarm or status messages.
LED (red) LED (red blinking) indicates the first occur-
rence of an alarm or status message (blink-
ing) or that an acknowledged alarm or status
message is still present (constant glow).
"SET" button with Sets changed parameters or adjusted values.
LED (yellow) LED blinks to request the pressing of this but-
ton.
"DIM" and "SET" Activates the Test function if both buttons are
buttons pressed simultaneously.
An interactive test (for the operator of the
NautoPilot Operator Unit) is performed to
check the operating elements and the touch-
screen and its function.
Combined rotary Presets a heading and activates adjusted set
knob/button heading value.
48
Edition: September 2014