Raytheon NautoPilot NP 5100 Operator's Manual page 64

Figure 22/11 Softkey for selecting displays with other content:
Figure 22/12 Softkey for showing and editing general settings for control functions of
Figure 22/13 Softkey for changing the value for a heading change performed either
Figure 22/14 Alphanumerical information about the mode for heading changes (se-
Figure 22/15 Display that shows the rate of turn or the radius value for a heading
Figure 22/16 Bar that indicates the actual rudder position.
Figure 22/17 Softkey for changing the value for a heading change performed either
Figure 22/18 Softkey for switching between Economy mode and Precision mode
Figure 22/19 Softkey for switching between radius controlled heading changes and
4002.DOC010102
OPERATION
NautoPilot 5000 Series
-- HDG/Rudder plot: displays heading versus rudder position in a
recorded graphic mode.
-- Track Data (-- not in Heading Control --): displays a track in a
recorded graphic mode.
-- NP 5000 Actual Rudder: displays the actual rudder position in a
graphic mode.
-- Acceleration Monitor: displays actual acceleration values in an
alphanumeric display (if configured).
-- Position Monitoring: displays all available satellites for position
calculation in a graphical mode (if configured).
-- Ship Data: displays all essential ship data
(set during configuration).
the Autopilot:
-- Limits
-- Values
-- Parameter
(independent from the configured values but limited by those values)
by a rate of turn function or by a radius function to a higher value.
Changed value must be acknowledged ("SET").
lectable by the softkey "Rad/RoT" (Figure 22/19)
change.
by a rate of turn function or by a radius function to a lower value.
Changed value must be acknowledged ("SET").
(-- not for NP 5100 --).
rate of turn controlled heading changes.
52
Function
Edition: September 2014