Table of Contents
Advertisement
Speed source
Speed value
Position source
Position value
Rudder limit
RAD/RoT
Course Trim
Heading monitor
Track Limit
OFF Position Limit Adjust Limit threshold for deviation between first and sec-
Alarm/Status
Edition: September 2014
OPERATION
NautoPilot 5000 Series
Check
The desired speed source is shown and can be adjusted
via the "Page" function:
Softkeys "Page""Value""Speed"
(see also section 2.3.6.2 and Figure 50)
The speed value must be valid.
If speed value is invalid, select "Manual Speed".
(see also section 2.3.6.2 and Figure 50)
If only one position sensor is available, and no speed
source is available, it is not possible to activate Course
Control (see also section 2.3.5.5).
The position value must be valid.
If no position sensor is available, it is not possible to acti-
vate Course Control (see also section 2.3.5.5).
Adjust rudder limit according to sea area and weather
conditions.
Softkeys "Limit" "Limit Page"
(see also section 2.3.6.4)
Adjust RAD/RoT values to be less than the ship's maxi-
mum values.
Softkey "Rad / RoT"
(see also sections 2.3 and 2.3.6.3)
Adjust Course Trim threshold for deviation from Set
Course Over Ground.
Softkeys "Limit "Limit Page"
(see also section 1.3.7 and 2.3.6.4)
Adjust Heading Monitor threshold according to traffic in
sea area; the more traffic, the smaller the threshold.
Softkeys "Limit" "Limit Page"
(see also section 2.3.6.4)
Adjust Track Limit threshold according to traffic in sea
area; the more traffic, the smaller the threshold.
Softkeys "Limit" "Limit Page"
(see also section 2.3.5.2 and 2.3.6.4)
ond position sensor, e.g. position sensor and dead reck-
oning.
Softkeys "Limit" "Limit Page"
(see also section 2.3.5.5 and 2.3.6.4)
The alarm, warning and status bar (top bar of the display)
should not be red/yellowish orange in colour.
The cause of alerts should be resolved.
Alerts should be acknowledged.
Comment
113
AUTOPILOT
4002.DOC010102
Hide quick links:
Advertisement
Table of Contents
