Table 15
Figure 56/1
Figure 56/2
Figure 56/3
to
Figure 56/6
Figure 56/7
Figure 56/8
To change a parameter set, press the appropriate softkey for the parameter set you wish
to change.
A small icon appears prompting the operator to press the "SET" button for a parameter
set change.
Edition: September 2014
OPERATION
NautoPilot 5000 Series
Meanings of Parameter memory
Actual values of the parameters yawing, rudder and counter
rudder. These values must not be identical to one of the below
parameter sets.
A selected parameter set (parameter set M1 is selected as
shown) can be changed with the "Parameter" softkey at the ini-
tial display -- this changed parameter values are displayed as
"Actual".
Parameter set M1, this parameter set is selected via the check
box.
If a parameter set is selected, "Parameter Set x" will be dis-
played in the upper right corner of the display.
Parameter sets M2 to M5 (not selected -- only one parameter
set can be selected).
Softkey for switching back to the previous display without a
modification/change of a parameter set.
Softkey for modifying the selected parameter set (not for acti-
vating this parameter set).
93
Function
AUTOPILOT
4002.DOC010102