Ou Display" Indication - Raytheon NautoPilot NP 5100 Operator's Manual

This principle is the same for "Heading Control" mode, "Course Control" mode and for
"Track Control" mode.
General information:
5.3.1

"OU Display" indication

This information is displayed at an inactive NautoPilot Operator Unit only if there are
more than one NautoPilot Operator Units in a steering system (refer to Figure 58).
It means that this NautoPilot Operator Unit serves only as a display.
At this NautoPilot Operator Unit no inputs are possible (except acknowledgement of
messages in the message bar).
But a selection of other displays is possible.
Figure 60: Indication "OU Display" in slave operator unit
4002.DOC010102
NautoPilot 5000 Series
At the active NautoPilot Operator Unit a green LED is on at the corresponding
mode button.
At the inactive NautoPilot Operator Units a yellow LED is on at the corresponding
mode button.
Green LED (off) and yellow LED (off) show the "Manual" mode.
Green LED (off) and yellow LED (on) show the "Standby" mode.
OPERATION
132
Edition: September 2014