Figure 5:
*
Standalone application: By switching the Main Steering Switch to AUTO the Autopilot controls at once in
AS application:
Edition: September 2014
OPERATION
NautoPilot 5000 Series
Heading Control after manual set heading adjustment
Heading CTRL
NautoPilot 5000 Series
Rotary knob
Manual Mode /
Standby
Heading
Control
Adjust Set
Heading
After Heading
Change
"Heading" mode.
Autopilot must display "Manual" before. Then, by switching the Main Steering
Switch to "AUTO", "Standby" is displayed and the NautoSteer System is ready
for control (but the Autopilot is not active). After pressing the button "Heading"
the Autopilot is active in "Heading" control.
HAND
SET
Actual Heading
Set Heading
Actual Heading
Set Heading
Actual Heading
Set Heading
Actual Heading
Set Heading
17
AUTOPILOT
AUTO --
Switch the Main
Steering Switch
to AUTO (actual
heading = set
heading)
*
or
--
Select
Heading Control
--
Adjust set heading
value with the rotary
knob
and
acknowledge this
value either by
pressing the rotary
knob or by pressing
the "SET" button
4002.DOC010102