1.4
Basic operation modes
1.4.1
Explanation of used symbols
Some symbols are used to explain these modes.
Below mentioned table shows their meaning.
Table 2
4002.DOC010102
NautoPilot 5000 Series
During any Autopilot control mode, switching over from one
connected sensor (for heading, position or speed) to another
sensor should not be performed.
However, if a switch over must be performed, it must be
verified that the difference in the sensor data is as small as
possible.
Please note:
Some basic operating modes differ in the type of
application, either standalone application or AS application.
Used symbols
Symbol
Key actuation
LED flashing
Set
LED out
Set
LED alight
Set
Acoustical signal on
Acoustical signal off
Top bar of the display.
Go To Waypoint
For colours and symbols,
see section 6 and , 6.1
for message texts, see
section 6.2.
OPERATION
Meaning
14
Edition: September 2014