Raytheon NautoPilot NP 5100 Operator's Manual page 75

Figure 30/12 Softkey for changing/entering the counter rudder parameter (see
Figure 30/13 Softkey for changing/entering the rudder parameter (see also
Figure 30/14 Softkey for changing/entering the yawing parameter (see also
Figure 30/15 Heading (waypoint) change mark; designates the point on the
Figure 30/16 Display with graphic information on Track and Distance to course-
Edition: September 2014
OPERATION
NautoPilot 5000 Series
also section 1.3.3). Value range: 0 to 9 (in increments of 1) .
Use the "+" and "--" softkeys to make a change.
Changes must be acknowledged with "SET" (a small icon is dis-
played after a change has been made, see Figure 31).
section 1.3.2). Value range: 1 to 9 (in increments of 1).
Use the "+" and "--" softkeys to make a change.
Changes must be acknowledged with "SET" (a small icon is dis-
played after a change has been made, see Figure 31).
section 1.3.1). Value range: 1 to 6 (in increments of 1).
Use the "+" and "--" softkeys to make a change.
Changes must be acknowledged with "SET" (a small icon is dis-
played after a change has been made, see Figure 31).
courseline (track) when a heading change is commanded or a
new waypoint is piloted.
line (track).
The distance between two dotted horizontal lines marks the time
difference of one minute.
63
Function
AUTOPILOT
4002.DOC010102