Table 28
Preselected COG
Set Course Over Ground
Caution!
"Course Approaching" is displayed at the top bar of the display.
Rotary knob is disabled and a new set course over ground input is not pos-
sible while the heading change manoeuvre is running.
If set course over ground value is reached the caution "Course Approaching"
is no longer displayed. Now it is possible to make a new course change ma-
noeuvre.
4002.DOC010102
NautoPilot 5000 Series
Procedure for a course change in "Course Control" mode
"Course Control" mode is active.
The mode is displayed at the top right corner of the dis-
play (Course Ctrl.).
Turning the rotary knob will change the set Course Over
Ground value.
Observe the 5 restriction.
Please note: After approx. 15 seconds of inactivity from
rotary knob, the previous Course Over Ground value is
displayed again.
125.8
This value is displayed in italic and bold.
The "SET" LED (near the button) will flash (request to
press the "SET" button).
Pressing the "SET" button transmits the preselected value
to the controller as the new "set Course Over Ground".
The value is now displayed in non--italics.
The "SET" LED (near the button) is off.
125.8
OPERATION
or
118
Edition: September 2014